Airlink101 AP421W Bedienungsanleitung Seite 1

Ver. 1B Quick Installation GuideModel # AP421WSuper G™ Wireless Access Point

Section 4Step 1 Select the Operating Mode tab to display the Operating Mode page.Step 2 Select the desired mode and enter the remote Access Point’s MA

AP ClientThe AP Client mode converts the Access Point to a wireless network adapter, allowing the networkdevice such as your computer or game console

Step 4 Click Apply to save the changes.Step 5 Once the Access Point has restarted, you may disconnect it from the wireless router and connectit to the

AP RepeaterThe AP Repeater mode converts the Access Point to a wireless repeater. By extending the wirelesssignal of the source AP/wireless router, th

Point to Point Bridge (WDS)The Point to Point Bridge mode converts the Access Point to a wireless bridge. It bridges the networkclients from two physi

Section 5Connecting to the Access PointOnce you have properly configured the Access Point, your wireless computers should be able to detectits signal.

Section 6Technical SupportE-mail: [email protected] Free: 1-888-746-3238Web Site: www.airlink101.com

Copyright © 2005 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 logo, specific product designations, and all other words andlogo

Section 1Getting StartedThis Quick Installation Guide only provides the basic instructions. For moredetailed information, please refer to the User’s M

Step 1 Connect one end of a network cable to the Network port of the Access Point and connect theother end to one of the LAN ports of the router (See

Section 2Gathering InformationStep 1 On the wired computer, go to Start, Run, type command (for Windows 95/98/ME) or cmd (forWindows 2000/XP) and clic

Step 1 Open your Web Browser (Internet Explorer or Netscape), enter the IP Address of the AccessPoint (default: 192.168.1.250) in the Address Bar and

Step 3 At the Wireless section, enter the SSID (Network Name) of your wireless network and thechannel number.Step 4 If you have enabled encryption for

Step 5a Select the same level of WEP encryption (64-Bits / 128-Bits) of your wireless network from thedrop-down menu.WEPStep 5b Enter the same WEP key

WPAStep 6 Select WPA from the drop-down menu and enter all the applicable fields. Click Save andproceed to Step 8.Step 7 Select WPA-PSK from the drop-

Step 8 Click Apply to save the changes.Step 9 For best result, place the Access Point at a central location where it is accessible to all thewireless