Airlink101 AEN-U55W Bedienungsanleitung

5.25” USB 2.0 Enclosure Box Model # AEN-U55W User’s Manual Ver. 1A

10 Step 6 Turn the plate over and secure the hard drive to the plate with the provided four screws. Step 7 Turn the plate over again and re-secure

11 Step 8 Connect the IDE cable and power cord to the hard drive and then hook plate B back to the enclosure. (Be sure to apply enough force to proper

12 3. Driver Installation for Windows 98SE This Enclosure Box supports Plug-and-Play for Windows ME, 2000, XP, and Mac OS. If you are using Windows 9

13 Step 3 Select Search for the best driver for your device (Recommended) and click Next. Step 4 Select the Specify a location check box and click

14 Step 5 Click Next to install the driver. Step 6 Click Finish to complete the driver installation.

15 4. Installation Verification To verify your installation, please follow the steps below. 4.1 Windows 98SE Go to Control Panel > System > D

16 4.2 Windows ME/2000/XP Go to Control Panel > System > Device Manager and look for USB Mass Storage Device under Universal Serial Bus control

17 4.3 Mac OS 10.x Go to Apple System Profiler > Devices and Volumes. If you see the Enclosure Box listed under USB Information, you have success

18 5. Drive Usage Now you are ready to use the attached drive as an external storage device. A brand new hard drive must be formatted and partitioned

19 For Mac OS Drag the corresponding USB disk icon that represents the hard drive to the trash can. When prompted, click OK and unplug the Enclosure

2 Table of Contents 1. Introduction...

Technical Support E-mail: [email protected] Toll Free: 1-888-746-3238 Web Site: www.airlink101.com *Ac

3 1. Introduction Thank you for purchasing this 5.25” USB 2.0 Enclosure Box. The Enclosure Box provides an easy way to add removable disk storage spa

4 2. Installation Follow the steps below for connecting a 5.25” CD/DVD Drive. If you are connecting a 3.5" hard drive, please skip Section 2.2,

5 Step 3 Remove the top cover. If you find it hard to open the cover, use the screwdriver to slightly push the locking tab inside. Step 4 Lift and

6 Step 5 Place the CD/DVD drive with the drive's top facing up and then connect the IDE cable and the power cord to the drive. Make sure the CD/D

7 Step 7 Re-attach the four pads to the enclosure box and then connect the supplied power adapter and USB cable to the enclosure box. Congratulatio

8 Step 2 Use the provided screwdriver to remove the screws on each side of the box. Step 3 Remove the top cover. If you find it hard to open the co

9 Step 4 Remove the two screws holding plate A and then remove plate A from plate B. Step 5 Remove plate B from the enclosure box and place the har